What is the standard height for a dining table?

The standard UK dining table height is 720-750mm (typically 735mm). This suits chairs with a seat height of 430-460mm, providing about 280-300mm of clearance between the seat and underside of the table top for comfortable seating.

How thick should table legs be?

For a dining table, legs should be at least 55-70mm square at the top where the apron joins. Tapered legs can reduce to 30-40mm at the foot. Thinner legs look more elegant but provide less racking resistance. For heavy tables over 1500mm long, consider 75mm legs.

What angle should tapered table legs be?

A typical taper angle for table legs is between 1 and 5 degrees. A gentle taper of 2-3 degrees looks elegant without compromising stability. The taper usually starts below the apron and runs to the foot. Both inner faces are typically tapered, leaving the outer faces straight.

How do I check if my table frame is square?

Measure both diagonals of the table frame. If they are equal, the frame is square. Use the diagonal measurement from this calculator as your target. When gluing up, clamp lightly, check diagonals, adjust by shifting clamp angles, then tighten fully.

What is an apron on a table?

The apron (or rail) is the horizontal frame member that runs between the legs beneath the table top. It provides rigidity, prevents racking, and supports the top. Standard apron height is about 1.5 times the leg width, typically 75-100mm for a dining table.

WoodCalcs

Table Leg Calculator — Leg Dimensions & Taper Angles

Calculate table leg length, taper angles, and apron dimensions for stable tables.

Table Type

Top Thickness

Leg Width at Top

Cross section at apron joint

Tapered legs

Taper from apron to foot

Table Length

For squaring diagonal check

Table Width

How We Calculate This

This calculator determines table leg dimensions based on the desired table height, top thickness, and leg style.

Key formulas

Leg length = Target table height - Top thickness

Apron height = Leg width at top x 1.5 (rule of thumb for proportional design)

Taper angle = arctan((Width top - Width bottom) / (2 x taper length))

The taper length is the leg length minus the apron height (taper starts below the apron). The diagonal check uses the Pythagorean theorem for squaring the frame.

Frequently Asked Questions

Related Calculators

Shelf Span Calculator

Calculate maximum shelf span before sagging based on material and load.

Drawer Slide Calculator

Work out drawer and slide dimensions for smooth-running drawers.

Chair Seat Height Calculator

Determine ergonomic chair dimensions based on user height.

Bookcase Calculator

Calculate shelf spacing, material quantities, and dimensions for bookcases.

Cabinet Door Calculator

Work out cabinet door dimensions and overlay calculations.

Last updated: February 2026

All calculations are estimates. Always verify measurements and material quantities before cutting or purchasing.